Daz Figure Height Software Programs As

In other words, rotation occurs when you move an objects local axes, relative to the global axes, without moving the local origin.

This page exists within the Old ArtZone Wiki section of this site.

Read the information presented on the linked page to better understand the significance of this fact.

As you work in DAZ Studio, you will undoubtedly want to move objects around your scene.

You accomplish this by exercising the first and easiest type of motion: Translation.

Translation occurs when an objects local origin moves in relation to the global origin, assuming that the local and global axes do not move.

Youve already learned that DAZ Studio refers to the three-dimensional axes as X, Y, and Z.

Daz Figure Height Software Programs As

These designations are part of what is known in 3D software programs as the Cartesian coordinate system.

This system uses these three axes to represent the three dimensions.

The 3D universe extends an infinite negative and positive distance in each dimension, and the origin is literally the center of that universe.

The center of the DAZ Studio universe lies on the floor in the exact center of your scene.

From that point, you can use the xtran, ytran, or ztran Parameter dials to move your objects in a positive or negative direction as follows.

Negative numbers move it down, and positive numbers move it up.

Negative numbers move it backward, and positive numbers move it forward.

To show an example, use the Create New Primitive Cube command to place a cube inside an empty scene.

It loads in the exact center of the default viewport, at the (0,0,0) position.

Now, say you want to move your object 60 units to the left of the origin point.

The Cartesian coordinate system now looks at the position as (-60,0,0) because the position is always listed as (X,Y,Z).

What if you want to move the object in more than one direction You already have the cube moved 60 units to the left, but lets say you want to position your object 70 units up, and 90 units backward.

Simply adjust the Y Translate dial to 70 to move the cube up, and the Z Translate dial to -90 to move the object backward.

You can see the results of the preceding example below, where the original position is shown partially transparent.

The red line indicates the X axis, the green line indicates the Y axis, and the blue line indicates the Z axis.

The darker cube is the cube that has been relocated to the new position in the scene.